To upgrade SFLTC v1.02 to v1.03 :

[ 1 ]  Copy SETUP.EXE and SFLTC.EXE over the previous version.

[ 2 ]  Load your SFLTC.CFG file into a text editor like MS-DOS EDIT.

[ 3 ]  Go to line 8 and:
       * To exclude security levels ABOVE the configured security level
         -  Add a greater than operator ( > ) after the security level 
            with no space between.  Example : 100>  
           
       * To exclude security levels BELOW the configured security level
         -  Add a less than operator ( < ) after the security level 
            with no space between.  Example : 20<  
       
       * To exclude security levels EQUAL to the configured security level
         -  Add an equal operator ( = ) after the security level with no 
            space between.  Example : 999=  

[ 4 ]  Save your CFG file.  Make sure your editor saves with no formatting
       codes imbedded in the CFG file.


That's all there is to it!   Of course you could use the setup program and do
the same thing, but you would have to enter all the information over again.

NOTE:  If a greater than, less than, or equal operator is not added to the
       configured security level then SFLTC will include ALL security
       levels in the displays.